STIEBEL ELTRON HDB-E 11/13 Trend - 10 Installation; Standard Installation

INSTALLATION
In sta Ration
10. Installation
Factory settings
Temperature °C
Connected load kW
HDB-E HDB-E 18 HDB-E HDB-E 27
11/13 Trend 18/21/24 Trend
Trend 25A Trend
55 55 55 55
13.5 18 21 27
Adjustable connected
load
X
-
X
Standard installation
Electrical connection from
below, flush - mounted
HDB-E HDB-E 18 HDB-E HDB-E 27
11/13 Trend 18/21/24 Trend
Trend 25A Trend
X x x x
Water connection,
flush - mounted
x x x X
For further installation options, see chapter " Alternative instal-
lation methods".
10.1 Standard installation
Opening the appliance
> Open the appliance by holding the fascia at the side and pull-
ing forwards away from the appliance cover. Undo the screw.
Pivot open the appliance cover.
> Remove the back panel by pressing the two locking tabs and
pulling the lower back panel section forwards.
Preparing the power cable on unfinished walls, for connection
from below
1 Cable entry installation aid
I> Prepare the power cable.
Fitting the wall mounting bracket
> Mark out the holes for drilling using the installation tem-
plate. If the appliance is to be installed on finished walls, also
mark out the fixing hole in the lower section of the template.
> Drill the holes and secure the wall mounting bracket at
2 points using suitable fixing materials ( screws and rawl
plugs are not part of the standard delivery).
> Fit the wall mounting bracket.
Installing the twin nipples
O
Property damage
Carry out all water connection and installation work in
accordance with regulations.
> Seal and insert the twin nipples.
Making the water connection
1 DHW with tee
2 Gasket
3 Cold water with 3- way ball shut-off valve
4 Strainer
5 Plastic profile washer
> Secure the tee and 3- way ball shut-off valve, each with a flat
gasket, to the twin nipple.
O
Property damage
The strainer must be fitted for the appliance to function.
> When replacing an appliance, check whether the
strainer is installed.
www.stiebel-eltron.com HDB-E Trend I 29