STIEBEL ELTRON HDB-E 11/13 Trend - Electrical Connection on Unfinished Walls from below with Short Power Cable; Electrical Connection, Surface- Mounted; Connecting a Load Shedding Relay; Water Installation, Surface- Mounted

INSTALLATION
Installation alternatives
-
13.2 Electrical connection on unfinished walls from
below with short power cable
> Reposition the mains terminal further downwards. To do this,
undo the fixing screw. Secure the mains terminal in place.
13.3 Electrical connection, surface- mounted
[il -E1
Notice
This type of connection changes the IP rating of the ap-
pliance.
> Change the type plate. Cross out " IP 25" and mark
the box " IP 24". Use a ballpoint pen to do this.
i Cable grommet
Electrical connection, surface- mounted
Positioned in lower section of appliance
Positioned in upper section of appliance 110
Dimension A
160
> Prepare the power cable. Fit the cable grommet.
Property damage
If you break out the wrong knock-out in the back panel/
appliance cover by mistake, you must use a new back
panel/appliance cover.
> Cleanly cut and break out the required cable entries from the
back panel and appliance cover ( for the positions, see chap-
ter " Specification / Dimensions and connections"). Deburr any
sharp edges with a file.
> Route the power cable through the cable grommet.
> Connect the power cable to the mains terminal.
13.4 Connecting a load shedding relay
Install a load shedding relay in the distribution board in conjunc-
tion with other electric appliances, e.g. electric storage heaters.
The relay responds when the instantaneous water heater starts.
O
Property damage
Connect the phase that switches the load shedding relay
to the indicated terminal of the mains terminal in the
appliance ( see chapter " Specification / Wiring diagram").
13.5 Water installation, surface- mounted
MEI
Notice
This type of connection changes the IP rating of the ap-
pliance.
> Change the type plate. Cross out " IP 25" and mark
the box " IP 24". Use a ballpoint pen to do this.
I> Fit water plugs with gaskets to seal the concealed connec-
tions. All taps obtained as accessories are supplied with
plugs and gaskets in the standard delivery. For pressure taps
other than those recommended by us, plugs and gaskets can
be ordered as accessories.
> Fit a suitable pressure tap.
> Push the lower back panel section under the connection
pipes of the tap and push it into the back panel.
> Secure the connection pipes to the tee and the 3- way ball
shut-off valve.
M
Notice
You can break off the pipe fitting tabs on the lower back
panel section if required.
1 Tab
34 I HDB-E Trend www.stiebel-eltron.com