STIEBEL ELTRON HDB-E 11/13 Trend - 11 Commissioning; Preparation; Initial Start-Up

ir\M -A I I AYMNI
Commissioning
11. Commissioning
,
dio _ — — —
>
e
Step-by-step guide
Commissioning
11.1 Preparation
Adjusting the temperature via jumper slot
> Install the jumper in the required position (= approximate
temperature in ° C) on the " Tmax" pin strip.
Jumper position Description
z 35 For hand washbasins
z 43 For example in nurseries, hospitals, etc.
z 50
z 55 ( Factory setting) For kitchen sink
No jumper Limit approx. 43 °C
Notice
Ensure that the set temperature is available at a rated
voltage of 400 V. If the rated voltage is lower, the outlet
temperature is reduced. The table below shows the effect
on the outlet temperature subject to the applied rated
voltage and the set temperature.
Jumper position Outlet temperature Outlet temperature
at 40 O V* at 380 V*
2-- 35 35,0 °C 33,0 °C
2-- 43 43,0 °C 40,0 °C
z 50 50,0 °C 46,0 °C
z. 55 55,0 °C 50,5 °C
* Cold water inlet temperature: 15 ° C
Changing the connected load via the jumper slot; only for
appliances with selectable connected load
If you select a connected load other than the factory setting for
appliances with selectable connected load, you will need to repo-
sition the jumper.
> Install the jumper in the required position on the " Pmax" pin
strip.
Jumper position Connected load
HDB-E 11/13 Trend HDB-E 18/21/24 Trend
1 it kW 18 kW
2 ( Factory setting)
3
13.5 kW 21 kW
it kW 24 kW
No jumper 11 kW
11.2 Initial start-up
18 kW
> Open and close all connected draw- off valves several times
for at least one minute until all air has been purged from the
pipework and the appliance.
> Carry out a tightness check.
> Activate the safety switch by firmly pressing the reset button
(the appliance is delivered with the safety switch disabled).
IM
Notice
For undersink installation, the appliance cover can be
turned the other way up; see chapter " Installation alter-
natives / Rotated appliance cover".
> Hook the appliance cover at the top rear into the back panel.
Pivot the appliance cover downwards. Check that the appli-
ance cover is securely seated both top and bottom.
32 I HDB-E Trend www.stiebel-eltron.com