STIEBEL ELTRON HDB-E 11/13 Trend - Installation with Offset Tiles; Rotated Appliance Cover; Horizontal Installation of the Appliance

TRICTA I I ATTnRI
Installation alternatives
13.10 Installation with offset tiles
1 Minimum contact area of the appliance
2 Maximum tile offset
> Adjust the wall clearance. Lock the back panel in place using
the fixing toggle ( turn 90° clockwise).
13.11 Rotated appliance cover
The appliance cover can be turned the other way up for undersink
installation.
> Remove the front panel from the apprance cover by pressing
the locking tabs and taking out the front panel.
> Turn the appliance cover ( not the appliance) the other way up
and refit the front panel. Keeping it parallel, push the front
panel in until all locking tabs engage. When engaging the
locking tabs, apply counter pressure by pushing against the
appliance cover from the inside.
WARNING Electrocution
ADJ. locking tabs on the front panel must click into place.
The locking tabs must be complete and undamaged. If
the front panel is not inserted correctly, user protection
against contact with live components cannot be ensured.
> Hook the appliance cover in at the bottom. Pivot the appli-
ance cover up to the back panel.
> Secure the appliance cover.
> Fit the cover onto the appliance cover.
13.12 Horizontal installation of the appliance
Notice
For the horizontal installation alternative, please note
the following points:
- Installation is only permissible with direct wall
mounting. The universal mounting frame cannot be
used
- The installation versions " Installation with offset
tiles" and " Rotated appliance cover" are not permis-
sible.
- This type of connection changes the IP rating of the
appliance. Cross out " IP 25" on the type plate and
mark the box " IP 24". Use a ballpoint pen to do this.
Horizontal installation
The appliance can also be mounted horizontally on the wall
(turned 90° to the left, with the water connections on the right).
The installation, water and electrical connections are described
in chapters " Standard installation" and " Installation alternatives".
1 Cold water inlet
2 DHW outlet
Preparation
The appliance cover must be provided with a condensate drain
opening of min. 0 5.0 mm to max. 0 6.0 mm at the marked po-
sition.
1 Appliance cover with opening for condensate drain
2 Back panel with additional fixing screw
> Drill a hole from the outside through the dismantled appli-
ance cover at the marked point. Alternatively, you can punch
a hole in the appliance cover from the inside at the marked
point. In this case, you must then enlarge the hole to the
required diameter from the outside. Deburr any sharp edges
with a file.
> Secure the appliance back panel with an additional screw.
C
OE
Property damage
An appliance cover with an existing condensate drain
opening must no longer be used for vertical installation
of the appliance.
36 I HDB-E Trend www.stiebel-eltron.com