STIEBEL ELTRON HDB-E 11/13 Trend - Page 30

INSTALLATION
Installation
Removing the flow limiter
Notice
If you are using a thermostatic valve, you must not re-
move the flow limiter.
If the flow rate is too low, remove the flow limiter. To do this,
remove the function module from the appliance back panel.
> Release the locking tab.
> Push the function module on the back panel gently
backwards.
> Remove the function module from the appliance back panel
by pulling it slightly forwards and lifting it off.
1 Cold water pipe bend with recess for spring clip
2 0-ring
3 Flow limiter
4 Spring clip
5 Heater
> Remove the cold water pipe bend and the 0-ring.
> Remove the flow limiter from the cold water inlet of the heat-
er using a pointed object or suitable pliers.
> Fit the cold water pipe bend with the 0-ring.
O
Property damage
The 0-ring must be fitted to prevent the appliance from
leaking.
> As part of installation, check that the 0-ring is in
place.
> Secure the cold water pipe bend with the spring clip.
O
Property damage
Ensure that the spring clip is located behind the recess
in the pipe bend and that it is securely holding the pipe
bend in place.
> Fit the function module on the appliance back panel in re-
verse order until it clicks into place.
30 I HDB-E Trend www.stiebel-eltron.com