STIEBEL ELTRON SHP-F 220 Premium - Appliance Parameters

INSTALLATION
Specication
38 | SHP-F 220-300 Premium www.stiebel-eltron.com
SHP-F 220 Premium SHP-F 300 Premium SHP-F 300 X
Premium
Sound emissions
Indoor sound power level with 4m air duct (EN 12102) dB(A) 52 52 52
Indoor sound power level without air duct (EN 12102) dB(A) 60 60 60
Average indoor sound pressure level at 1m distance, free field with 4m air duct dB(A) 37 37 37
Average indoor sound pressure level at 1m distance, free field, without air duct dB(A) 45 45 45
Versions
IP rating IP 24 IP 24 IP 24
Refrigerant R134a R134a R134a
Refrigerant charge kg 0.85 0.85 0.85
Global warming potential of the refrigerant (GWP100) 1430 1430 1430
CO
2
equivalent (CO
2
e) t 1.216 1.216 1.216
Power cable length approx. mm 2000 2000 2000
Dimensions
Height mm 1501 1905 1905
Diameter mm 690 690 690
Height when tilted mm 1652 2026 2026
Height when tilted incl. packaging mm 1910 2244 2244
Packing unit dimensions height/width/depth mm 1740/790/790 2100/790/790 2100/790/790
Weights
Weight, empty kg 120 135 156
Connections
Condensate connection G 3/4 A G 3/4 A G 3/4 A
DHW circulation connection G 1/2 A G 1/2 A G 1/2 A
Water connection G 1 A G 1 A G 1 A
Heat exchanger connection G 1
Air duct connector, side mm 200/160 200/160 200/160
Air duct connector, top mm 160 160 160
Values
Type of anode Impressed current
anode
Impressed current
anode
Impressed current
anode
Air flow rate m³/h 350 350 350
Available external pressure Pa 120 120 120
Max. air duct length at 160/200mm diameter (including 3x 90° bends) m 20/40 20/40 20/40
Recommended number of users ≤ 4 ≤ 6 ≤ 6
The output data refers to new appliances with clean heat exchangers.
Nominal data to EN 16147 / Recirculation air or outdoor air mode
Further details
SHP-F 220 Premium SHP-F 300 Premium SHP-F 300 X
Premium
238630 238631 238632
Maximum altitude for installation m 2000 2000 2000
16.5 Appliance parameters
SHP-F 220 Premium SHP-F 300 Premium SHP-F 300 X
Premium
Reduced start hysteresis K 6 6 6
Maximum temperature increase time h 13 13 13
Maximum defrost time min 60 60 60
Defrost end temperature °C 5 5 5
Set setback value °C 52 52 52
Minimum evaporator temperature °C -20 -20 -20
Recurring pressure fault - 5 5 5
Pressure fault evaluation time h 5 5 5
Compressor lockout time min 20 20 20
Set rapid heat-up temperature °C 65 65 65
Start temperature for the frost protection function °C 8 8 8
Set temperature 1 ( Factory setting ) °C 55 55 55