11
2.3 Remote control FE 7
DHW programs
The DHW PROG menu item enables you to
adjust the times for the day and night tempe-
ratures for DHW heating.
You can adjust your DHW heating as follows:
– for each individual day of the week
(Monday, ..., Sunday)
– Monday to Friday (Mo - Fr)
– Saturday and Sunday (Sa - Su)
– the whole week (Mo - Su)
You can adjust three switching time pairs (I, II,
III) for each of these options.
Exception:
You will need two switching time pairs, if you
want to heat DHW from 22:00 h until 06:00
h the following day. This determines, when
and how often the heat pump system should
heat/load DHW in day mode. You will already
have selected the corresponding set values for
day and setback mode under the DHW TEMP
system parameter.
Example:
You want to heat up DHW daily at two dif-
ferent times, i.e. from 22:00 h until 06:00 h
the following day, and then again from 08:00
h until 09:00 h.
The day begins at 00:00 h; therefore begin
programming for this example at 00:00 h. The
first switching times pair runs from 00:00 until
06:00 h. The second switching times pair runs
from 08:00 until 09:00 h. The third switching
times pair runs from 22:00 until 24:00 h.
Open the control ap.
DHW PROG
MO to SUN
DHW START 45C
DHW STOP 45C
DHW START 45C
DHW STOP 45C
DHW START 45C
DHW STOP 45C
MON to SUN
Back
DHW PROG
The FE 7 remote control enables you to
change the set room temperature for heating
circuit 1 or heating circuit 2 by ± 5 °C, as well
as the operating mode.
The remote control offers the following:
• one rotary selector for modifying the set
room temperature
• one rotary switch with the following po-
sitions:
Programming mode
Constant setback mode
Constant day mode
The remote control is only active in the WPM
programmed mode.
To Next Page
Loading...
