EN - 4
3.2. STEERING WHEEL ASSEMBLY
3.3. SEAT ASSEMBLY
3.4. MOUNTING AND CONNECTING THE
BATTERY
First connect the red wire (Fig. 5.C) to the positive pole (+)
using the screws supplied as shown.
3.5. FITTING THE SUPPORTS AND REMOVING
THE GRASS CATCHER RETAINING PAWL
3.6. MOUNTING THE REAR BUMPER
3.7. GRASS CATCHER BAG ASSEMBLY
3.8. MOUNTING THE GRASS CATCHER
TIPPING LEVERS
3.9. MOUNTING THE CUTTING MEANS
3.10. SIDE DISCHARGE CHUTE ASSEMBLY
4. CONTROLS
•
on the rear wheels.
•
Forward drive gear: Increasing the
goes into neutral position when released.
•
Reverse gear: Increasing the pressure
Reverse must only be engaged
goes into neutral position when released.
•
Drive engaged.
Drive disengaged.
• Key switch(Fig. 15.A
Stop position.
On position.
Start position.
IMPORTANT Remove the key whenever the machine is left
unattended or not in use.
• Throttle command
(Fig. 15.B and
Fig. 15.C)
(Fig. 15.C)
Choke Command -
• (Fig. 15.D
Brake not engaged.
To Next Page
Loading...
