EN - 5
Brake engaged.
•
• Cutting means engagement and disengagement
Cutting means engaged.
Cutting means disengaged.
•
Press and hold the button to reverse
while the cutting means are engaged,
without causing the engine to stop.
•
Control with lever: this lever raises and lowers the cutting
Control with lever and knob: this lever raises and lowers
Position “A” =
Position “B” =
• Speed cruise control
Pressed: device disabled (deactivated)
Pulled: device enabled (active)
•
•
• Grass catcher tipping command
the lever (Fig. 15.L).
Electrical control:
operator must press and hold the button (Fig. 15.N) until
the command motor stops running.
retaining catch locks into place and the command motor
stops running.
•
Indicator light ON: cutting devices engaged
(Fig. 16.A).
Indicator light ON: parking brake engaged
(Fig. 16.B).
Indicator light ON: operator not present
(Fig. 16.C).
(Fig. 16.D).
Flashing indicator light: engine lubrication
check oil level and contact an Authorized
Service Centre.
Indicator light ON: grass catcher or rear
discharge guard missing (Fig. 16F).
Indicator light ON: when the engine is running
an Authorized Service Centre (Fig. 16.G).
Indicator light ON: transmission in “neutral”
(Fig. 16.H).
•
1. Continuous
acoustic signal:
• Electronic card protection
•
in the “DRIVE” position.
2. Intermittent
acoustic signal:
•
To Next Page
Loading...
