EasyManua.ls Logo

Stiga TCX 102

Stiga TCX 102
130 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
32. Warning: 
-

33. Danger! Ejected objects: Do not operate

the grass catcher being in place.
34. Danger! Ejected objects:-

35. Danger! Machine rollover: Do not use this

36. Danger! Dismemberment:


37. Danger of cutting yourself. Cutting

near or under the opening of the cutting

38. Warning!
2.4 REGULATIONS FOR TOWING
-

the instructions provided.
41. 


NOTE The images corresponding to the texts
in chapters 3 et seq., can be found on pages iii et
seq. of this manual.
3. UNPACKING AND ASSEMBLY
-

-

IMPORTANT The machine is supplied without
engine oil or fuel. Before starting up the engine,
fill with oil and fuel following the instructions given
in the engine manual.
WARNING! Unpacking and completing
the assembly should be done on a flat and
stable surface, with enough space for mov-
ing the machine and its packaging, always
making use of suitable equipment.
3.1 UNPACKING





 
 
 
 
 
 
 
 
 
the nuts and bolts,
 
NOTE To avoid damaging the cutting-means
assembly when getting the machine down from
the pallet, take it to the maximum height and be
very careful.
-


-

3.2 FITTING THE STEERING WHEEL
• Steering wheel Type “I” (Fig. 3.1)





-





in the indicated order.
-
ner.

fasteners into place.
• Steering wheel Type “Il” (Fig. 3.2)




proper direction and push it in until the steering



-
plied, in the indicated order.
-
ner.

Table of Contents

Related product manuals