WARNING! When cutting on sloping
ground, the forward speed must be reduced
to ensure safe conditions (see 1A – C7-8-9).
5.4.6 Emptying the grass catcher
(Fig. 5.9)
NOTE The emptying of the grass catcher can
only be done with the cutting means disengaged,
otherwise the engine stops.
Manual control
into place.
Electric control
NOTE The grass catcher tipping control
-
gaged.
-
NOTE At times the audible warning may be
heard at the moment of engaging the cutting
means even when the grass catcher has been
emptied. This is due to grass-cuttings left on the
sensor of the micro-switch. To stop the signal
disengage the cutting means and then immedi-
ately engage it again.
cuttings.
5.4.7 Unblocking the collector channel
-
-
-
WARNING! This job must only be per-
formed with the engine turned off.
5.4.8 End of mowing
-
5.4.9 End of work
When the engine has stopped, close the fuel
WARNING! To avoid backfire, put the
accelerator in the «SLOW» position for 20
seconds before stopping the engine.
IMPORTANT To keep the battery charged,
do not leave the ignition key in the «ON» position
when the engine is not running.
5.4.10 Cleaning the machine
electronic circuit board located under the dash-
board.
IMPORTANT Never use hose-nozzles or
harsh detergents for cleaning the body and en-
gine!
To Next Page
Loading...
