Stiga TRE 0702 - Checking the Oil Breather

Release 00 - 03/2018
pag. 40
Engine TRE 0701-TRE 0702-TRE 0801
Service manual
10. ENGINE BLOCK – External repairs
4 - Using a suitable extraction tool, remove the
ywheel (37) as indicated in the diagram.
Ensure that the engine shaft key is retained.
5 - Remount the coil (35) and x the screws (36) to
the indicated couple.
6 - Assembling the ywheel and verify the integrity
of the key (38) and remove it if it’s damaged; as-
semble the Air gap/ywheel (34) and the fan.
Close the nut to the indicated couple (32) and
utilize a gun.
7 - Remount the cowl [ 6.1].
10.6. Checking the oil breather
1 - Remove the magneto ywhee [
10.5].
2 - Unscrew the three screws (39) xing the closing
plate (40).
3 - Check that the reed (41) is not blocked or de-
formed. Replace if this is the case.
4 - Remount the plate (40) and replace the
washer (42).
5 - Ret the magneto ywheel [ 10.5].
39
40
41
42
37
38
INDEX
<< BACK >>