Stiga ZERO TURN Series

EN - 20
CHECK PARKING BRAKE
1. Place unit in service position. See
Service Position on page 19.
2. Set both transaxle bypass levers in the
rear position. See Move Unit Manually on
page 18.
3. Push unit forward.
• If unit does not move forward, no further
action is needed.
• If unit easily moves forward, adjust the
brake lever. See Adjust Parking Brake
Lever on page 28.
CHECK ENGINE OIL
NOTICE: Engine oil level must be maintained
at correct level or engine damage may occur.
Refer to engine manual.
CHECK TYRE PRESSURE
See Specifications on page 35 for
recommended tyre pressure.
CHECK FASTENERS
Check for loose or missing hardware.
Test Steering
Levers
PTO Parking
Brake
Result
Starting Interlock
1 Neutral Off On Engine
starts.
2Forward,
Neutral,
Reverse
On On or
Off
Engine does
not start.
3Forward,
Neutral,
Reverse
On
or
Off
Off Engine does
not start.
Operating Interlock (Engine On)
4 * Forward,
Neutral,
Reverse
On On or
Off
Engine
shuts off.
5 * Forward,
Neutral,
Reverse
On
or
Off
Off Engine
shuts off.
* When operator lifts off seat.
WARNING: AVOID INJURY.
Explosive separation of tyre
and rim parts is possible.
• DO NOT inflate tyres above
the recommended pressure.
• DO NOT inflate tyres with a
compressor; use a hand
pump.
• DO NOT stand in front of
tyre assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
• DO NOT put a tyre on the
rim without proper
equipment and experience.