15BR 500, BR 550, BR 600
: Position the outer spring loop at
distance “a” (30 mm) from the
edge of the special tool (1).
: Wind the rewind spring
counterclockwise, from the
outside inwards.
– To simplify this operation, place
the assembly block
1108 893 4800 across the top of
the special tool.
: Place the special tool (1) with the
rewind spring on the spring
housing.
The outer spring loop must line up
with the recess in the spring
housing (arrow).
– Install the rope rotor, b 5.4
Install all other parts in the reverse
sequence.
– Remove the starter cover with
rewind starter, b 5.2
: Make a loop in the starter rope.
: Engage the rope in the notch
(arrow) in the rotor. Grip the rope
close to the rotor and use it to
turn the rotor six full turns
counterclockwise.
5.8 Tensioning the Rewind
Spring
RA_452_00_01_02.book Seite 15 Donnerstag, 16. Februar 2012 11:52 11
To Next Page
Loading...
