Stihl BR 500 - 9 Control Handle; Throttle Trigger;Interlock Lever; Setting Lever

52 BR 500, BR 550, BR 600
: Take out the screw (arrow).
– Remove the control handle.
452RA140
VA
: Take out the screws (arrows)
– Remove the outer handle
molding (1).
452RA141
VA
1
: Remove the torsion spring (1).
: Remove the throttle trigger (2)
with lever (3).
– Disconnect the throttle cable.
452RA142
VA
2
3
1
: Swing the lever (1) sideways and
remove it upwards.
– If necessary, take out the grub
screw (arrow).
452RA144
1
VA
: Remove the interlock lever.
Install in the reverse sequence.
– Adjust the throttle cable, b 9.3.2
452RA143
VA
1
– Remove the interlock lever,
b 9.1
: Remove the torsion spring (1).
: Take out the screw (2) and
remove the cam (3).
452RA145
2
VA
1
3
: Remove the setting lever (1).
Install in the reverse sequence.
452RA146
VA
1
– Make sure the teeth of the setting
lever mesh with those of the cam.
452RA147
VA
9. Control Handle
9.1 Throttle Trigger/Interlock
Lever
9.2 Setting Lever
RA_452_00_01_02.book Seite 52 Donnerstag, 16. Februar 2012 11:52 11