Stihl BR 500 - 11 Fan; Outer Fan Housing

55BR 500, BR 550, BR 600
: Push the locking tabs (arrows)
down and lift the protective
screen (1) upwards and away.
Install in the reverse sequence.
452RA086
1
VA
: Locate lugs (1) on bottom of
protective screen in the holes
(arrows) in the base of the
backplate.
– Carefully push the upper half of
the protective screen against the
backplate until the locking tabs
452RA087
VA
11
snap into position.
Install all other parts in the reverse
sequence.
: Unclip the throttle cable (1) with
grommet (3) from the hose
clamp (2).
: Take out the screw (arrow).
: Remove the hose clamp (2) and
pleated hose.
452RA154
2
VA
3
1
: Disconnect the lower half of the
antistatic wire (1) from the upper
half (2).
– Take the powerhead off the
backplate, b 10.2
452RA155
1
VA
2
: Take out the screws (arrows).
: Remove the outer fan
housing (1).
: Remove the elbow (2).
Install in the reverse sequence.
452RA088
1
VA
2
11. Fan
11.1 Outer Fan Housing
RA_452_00_01_02.book Seite 55 Donnerstag, 16. Februar 2012 11:52 11