24 BR 500, BR 550, BR 600
Note the installed position of the
spring (2).
Always cover the bore (arrow) with
a finger to stop components
popping out.
: Carefully pull out the throttle
shaft (1).
: Take the pump piston (1) with
sealing ring (2) and spring (3) out
of the carburetor body.
– Inspect components for damage
and wear, replace as necessary.
Install in the reverse sequence,
always using a new pump piston.
Install the parts of the accelerator
pump in the following sequence:
First fit the spring (2) in the pump
piston (1) and insert them both in
the bore (arrow). Slide the throttle
shaft (4) with spring (3) into the
carburetor body. Use a suitable tool
to carefully hold down the pump
piston and then push the throttle
shaft fully home.
: Check correct installed position
(arrows) of spring.
Install all other parts in the reverse
sequence.
: Check correct installed position
(arrows) of spring.
RA_452_00_01_02.book Seite 24 Donnerstag, 16. Februar 2012 11:52 11
To Next Page
Loading...
