EasyManua.ls Logo

Stihl FR 410 C - Adjusting Trimmer for User; Mixing Fuel and Refueling the Brushcutter

Stihl FR 410 C
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7 Adjusting Trimmer for User
7.1 Fitting and Adjusting the Carry‐
ing System
Put the carrying system on your back.
1
0000-GXX-7843-A0
Close buckle (1) on the waist belt.
2
0000-GXX-7844-A0
Tighten the straps until the waist belt fits
snugly on your hips and the back padding is
against your back.
Thread the end of the waist belt through the
loop (2).
7.2 Removing the Carrying System
Shut off the engine.
Loosen the straps.
Open the buckle on the waist belt.
Take the trimmer off your back.
8 Mixing Fuel and Refueling
the Brushcutter
8.1 Mixing fuel
The fuel required for this trimmer is a mixture of
gasoline and two-stroke engine oil, in a mixing
ratio of 1:50.
STIHL recommends you use STIHL MotoMix.
If you mix the fuel yourself, use only STIHL two-
stroke engine oil or another high-performance
engine oil in accordance with JASO FB, JASO
FC, JASO FD, ISO-L-EGB, ISO-L-EGC or ISO-L-
EGD.
STIHL specifies STIHL HP Ultra two-stroke
engine oil or an equivalent high-performance
engine oil in order to maintain emission limits
over the machine’s service life.
Make sure that the octane number of the gas‐
oline is at least 90 RON and the ethanol con‐
tent is not more than 10% (for Brazil: 27%).
Make sure the two-stroke engine oil you are
using meets requirements.
Depending on the desired amount of fuel,
determine the correct amounts of two-stroke
engine oil and gasoline in a mixing ratio of
1:50. Examples for fuel mixes:
20 ml Two-stroke engine oil, 1 l gasoline
60 ml Two-stroke engine oil, 3 l gasoline
100 ml Two-stroke engine oil, 5 l gasoline
Pour two-stroke engine oil into a clean
approved fuel canister first and then add gaso‐
line.
Stir the fuel before topping up.
8.2 Fueling the brushcutter
Shut off the engine.
Place your brushcutter on a level surface so
that the fuel tank cap faces up.
Use a damp cloth to clean the fuel tank cap
and the area around it.
0000099186_001
Turn the tank cap counterclockwise until it can
be removed.
Remove the fuel tank cap.
NOTICE
Exposure to light, direct sunlight and extreme
temperatures may accelerate fuel separation
or aging. The brushcutter can be damaged if it
is used with a fuel mix that has become sepa‐
rated or has aged.
Thoroughly mix the fuel.
Do not top up with fuel stored for more than
30 days (STIHL MotoMix: 5 years).
When topping up, ensure that no fuel is spil‐
led and that the fuel level remains at least
15 mm under the edge of the tank.
English 7 Adjusting Trimmer for User
14 0458-840-0101-A

Related product manuals