EasyManua.ls Logo

Stihl FR 410 C - Starting and Stopping the Engine

Stihl FR 410 C
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0000099187_001
Fit the fuel tank cap on the tank opening.
Turn the tank cap clockwise and tighten it
down firmly by hand.
The fuel tank is closed.
9 Starting and Stopping the
Engine
9.1 Starting the engine
Select the correct starting procedure.
Place the trimmer on a level surface so that
the cutting attachment does not touch the
ground or other objects.
Remove the transport guard.
1
A B
1
22
0000099192_001
Depress the manual fuel pump (1) at least 5
times.
If the following condition is met
The engine is at ambient temperature.
Press the choke lever (2) in at the edge and
move it to position (A).
If any of the following conditions is met:
The engine has been running for at least 1
minute and has only been shut down for a
short break in work.
The engine has sparked in the
position
and then switched off.
Press the choke lever (2) in at the edge and
move it to position (B).
4
3
0000099451_001
NOTICE
The brushcutter can be damaged if pressed
into the ground with your foot or knee.
Press the brushcutter against the ground
with your left hand. Do not stand or kneel
on the shaft.
Press the brushcutter against the ground with
your left hand.
Pull the starter grip slowly with your right hand
until you feel it engage.
Pull the starter grip quickly and allow the
starter rope to rewind several times until the
engine runs.
Briefly press the lockout lever (3) and throttle
trigger (4).
The choke control (2) springs to the position.
The engine runs at idling speed.
If the engine is cold: Warm up engine by
briefly opening the throttle.
If the cutting attachment rotates when the
engine is idling: Rectify the malfunction.
Idle speed adjustment is not correct.
If the engine switches off in the
position or
when you open the throttle: Move the choke
lever (2) into the position and try to start the
engine again.
If the engine does not start in the
position:
Move the choke lever (2) to the position
and try again to start the engine.
If the engine is flooded: Try to start the engine
again with the choke lever (2) in the position.
9.2 Shutting off the engine
3
2
1
0000099200_001
9 Starting and Stopping the Engine English
0458-840-0101-A 15

Related product manuals