Stihl FS 360 C - Fueling; Fitting the Full Harness

FS 260 C, FS 360 C
English
28
Preparations
WARNING
When fueling on a slope, always position
the machine so that the fuel filler cap is
facing uphill.
N On level ground, position the
machine so that the fuel filler cap is
facing up.
N Before fueling, clean the fuel filler
cap and the area around it to ensure
that no dirt falls into the tank.
Always thoroughly shake the mixture in
the canister before fueling your
machine.
WARNING
In order to reduce the risk of fire and
personal injury from escaping gas vapor
and fumes, remove the fuel filler cap
carefully so as to allow any pressure
build-up in the tank to release slowly.
Opening the fuel filler cap
N Turn the fuel filler cap
counterclockwise until it can be
removed from the tank opening.
N Remove the fuel filler cap.
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Closing the fuel filler cap
N Position fuel filler cap.
N Turn the fuel filler cap clockwise as
far as it will go and tighten it as
securely as possible by hand.
Fitting the full harness is described in
detail in the instruction sheet supplied.
The type and style of the harness
depend on the market.
FS 260
Putting on the harness
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
Fueling
2709BA025 KN
2709BA003 KN
2709BA004 KN
Fitting the Full Harness
2
002BA607 KN
1