FS 510 C-M, FS 560 C-M
English
42
Fitting Fresh Nylon Line
PolyCut mowing head
A length of nylon line can be fitted to the
PolyCut in place of the cutting blades.
N Shut off the engine.
To reduce the risk of injury, always shut
off the engine before refilling the mowing
head.
N Fit nylon line in mowing head as
described in the instructions
supplied.
PolyCut Mowing Head
Always check the mowing head for signs
of wear before installing new cutting
blades.
If there are signs of serious wear,
replace the complete mowing head.
The thermoplastic cutting blades are
referred to as "blades" in the following.
The mowing head is supplied with
illustrated instructions for replacing the
blades. You should therefore keep the
instructions for the mowing head in a
safe place.
Preparing the machine for installation of
new blades
N Shut off the engine.
To reduce the risk of injury, always shut
off the engine before installing new
blades.
N Put the power tool on the ground
with the mowing head facing up.
N Remove the mowing head.
Replacing the Cutting Blade
To Next Page
Loading...
