FS 510 C-M, FS 560 C-M
English
40
N Pull out and straighten the twisted
rope at the starter grip.
N Hold the rope steady with the starter
grip.
N Release the tensioning wrench and
rope slowly so that it winds onto the
rotor.
N Remove the tensioning wrench.
The starter grip must locate firmly in the
guide bushing. If the grip droops to one
side: Add one more turn on the rope
rotor to increase spring tension.
When the starter rope is fully extended it
must still be possible to rotate the rotor
at least one more turn. If this is not the
case, the spring is overtensioned and
could break.
N Take one turn of the rope off the
rotor.
Installing the Rewind Starter
N Position and line up the rewind
starter on the engine.
N Insert the screws (1) and tighten
them down firmly.
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Remove, clean and inspect the
cutting attachment.
N Thoroughly clean the machine.
N Store the machine in a dry and
secure location – out of the reach of
children and other unauthorized
persons.
To Next Page
Loading...
