FT 250
English
18
Adjusting the straps
Adjust the length of the straps with the
front (arrow) and rear sliding adjusters.
Tightening the straps
N Pull the end of the strap down to
tighten the strap.
Loosening the straps
N Push the sliding adjuster up to
loosen the strap.
N Adjust the length of the strap so that
the machine and cutting attachment
point downwards at a shallow angle.
Removing the machine
N Grip the handle support with your
right hand and lift the machine.
N Lift the strap off your left shoulder
and over your head with your left
hand.
Shoulder Strap with 1 Carabiner (special
accessory)
The shoulder strap with 1 carabiner
requires a carrying ring between the
handle support and padding.
Use either the front carrying ring or an
additional carrying ring (available as
special accessory).
Fitting the carrying ring
N Place the clamp (1) against the
drive tube with the tapped hole on
the left (viewed from engine).
N Squeeze the two ends of the clamp
together and hold in that position.
N Insert the M6x14 screw (2).
N Line up the carrying ring.
N Tighten down the screw firmly.
To Next Page
Loading...
