HT 105, HT 134, HT 135
English
37
N Press the boot (2) firmly onto the
spark plug.
N Fit the cover (1) and screw it down
firmly.
For periods of about 30 days or longer
N Drain and clean the fuel tank in a
well-ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N If a manual fuel pump is fitted: Press
the manual fuel pump at least 5
times.
N Start the engine and run it at idling
speed until it stops.
N Remove saw chain and guide bar;
clean and spray with protective oil
N Thoroughly clean the machine - pay
special attention to the cylinder fins
and air filter
N When using biological chain oil (e.g.
STIHL BioPlus), fill the lubricant oil
tank
N Store the machine in a dry and
secure location Keep out of the
reach of children and other
unauthorized persons
N Remove chain sprocket cover, saw
chain and guide bar
Replace the chain sprocket
– replace after using two saw chains
or sooner
– if the wear marks (a) are deeper
than 0.02 in (0.5 mm) since this
would reduce the service life of the
saw chain. Use a gauge (special
accessory) to check the depth of the
wear marks
Using two saw chains in alternation
helps preserve the chain sprocket.
STIHL recommends the use of original
STIHL chain sprockets.
Storing the Machine Checking and Replacing the
Chain Sprocket
To Next Page
Loading...
Need help?
General
