17KW 85
english / USA
As soon as the engine runs:
: Blip the throttle trigger - the
slide control moves to the run
position # -
and the engine settles down to idle
speed.
Make sure carburetor is correctly
adjusted - the sweeper drums must not
rotate when engine is idling.
Your machine is now ready for
operation.
To shut down the engine:
: Move the slide control in the
direction of c to $ .
At very low outside temperatures:
Allow the engine to warm up.
As soon as engine runs:
: Blip the throttle trigger to disengage
the starting throttle position -
the slide control moves to the run
position # and the engine returns to
idling speed.
: Open the throttle slightly.
: Allow engine to warm up for a brief
period.
If the engine does not start:
If you did not move the choke lever
to e quickly enough after the engine
began to fire, the combustion chamber is
flooded.
: Move choke lever to e
: Set slide control, interlock lever and
throttle trigger to starting throttle
position.
: Crank the engine - pull the starter
rope briskly - 10 to 20 pulls may be
necessary.
If the engine still does not start:
: Move the slide control in direction of
c to $
: Pull off the spark plug boot (10).
: Unscrew and dry off the spark plug.
: Open the throttle wide.
: Crank the engine several times with
the starter to clear the combustion
chamber.
: Refit the spark plug and connect the
spark plug boot - push it down firmly.
: Move slide control to START.
: Set choke lever to e , even if
engine is cold.
: Now start the engine.
Fuel tank run until dry and then
refueled
: Press the fuel pump bulb at least
five times - even if bulb is filled with
fuel.
: Now start the engine.
393BA019 KN
10
To Next Page
Loading...
