Stihl MS 360 C User Manual

44
english / USA
MS 360 C
: Remove the foam filter element (5)
from the front half (6) and clean or
replace as necessary.
: Knock the two halves of filter out on
the palm of your hand or blow them
clear with compressed air from the
inside outwards.
In case of stubborn dirt:
: Wash the filter components in
STIHL universal cleaner or a clean,
non-flammable solution (e.g. warm
soapy water) and then dry.
Do not use a brush to clean the fleece
filter.
: Always replace a damaged filter
element.
: Reinstall the air filter.
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
General Information
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
With this carburetor it is only possible to
adjust the engine idle speed within fine
limits.
6
5
138BA003K
Motor Management Adjusting the Carburetor

Stihl MS 360 C Specifications

General

Brand	Stihl
Model	MS 360 C
Category	Chainsaw
Language	English