MSA 160 C, MSA 200 C
English
36
If the red light emitting diodes glow
continuously / flash
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
– is being charged
– is too hot and must cool down
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger turns off as soon as the battery
is fully charged.
A 1 light emitting
diode glows
continuously
red:
Battery is too
hot
1) 2)
/cold
1)
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
B 4 light emitting
diodes flash red
Malfunction in
battery
3)
C 3 light emitting
diodes glow
continuously
red:
Power tool is too
hot – allow it to
cool down.
D 3 light emitting
diodes flash red
Malfunction in
power tool
4)
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic interference or
malfunction. Take the battery out of
the power tool and refit it. Switch on
the machine – if the LEDs continue
to flash, the battery has a
malfunction and must be replaced.
4)
Electromagnetic interference or
malfunction. Take the battery out of
the machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the power tool –
if the light emitting diodes still flash,
the power tool is malfunctioning
and must be checked by a servicing
dealer – STIHL recommends an
authorized STIHL servicing dealer.
Light Emitting Diodes (LED)
on Charger
To Next Page
Loading...
