MSA 160 C, MSA 200 C
English
37
Red flashing light ...
... indicates the following:
– No electrical contact between
battery and charger – remove and
refit the battery
– Malfunction in battery – see also
"Light Emitting Diodes (LEDs) on
Battery".
– Malfunction in charger – have it
checked by a servicing dealer.
STIHL recommends a STIHL
servicing dealer.
When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
time.
N Before inserting the battery, remove
the battery compartment cover if
there is one; to do this, press both
safety catches at the same time –
cover is unlocked – and remove the
cover
Inserting the battery
N Insert battery in the battery
compartment of the machine –
press gently until it clicks into place
– top of battery must be flush with
the top edge of the housing
Switching on the machine
N Remove the chain scabbard
N Assume a firm and secure stance
N Ensure that there are no other
persons within the swivel range of
the machine
N Hold the machine with both hands –
wrap hands tightly around the
handles
N Make certain that the saw chain has
not yet been positioned for cutting
and is not touching any other
objects
N Pull hand guard towards the front
handle until it engages audibly and
the hand guard is in the position ‚
– chain brake is released
N Press trigger switch lockout (1) with
thumb
N Depress trigger switch (2) with
index finger
N Guide the machine into the wood
with the saw chain running
The motor will not run unless the hand
guard is set to ‚ and the trigger switch
lockout (1) and trigger switch (2) are
pressed at the same time.
Switching On
To Next Page
Loading...
