RB 200
English
16
Removing
N Pull back the coupling sleeve (1) as
far as it will go and hold it there
N Pull the high-pressure nozzle (2)
out of the coupling
N Release the coupling sleeve
NOTICE
Lack of water can damage the high-
pressure pump. Only start the engine
when the water hose is connected and
the water supply is turned on.
N Connect the high-pressure hose
N Connect the water supply hose and
turn on the water supply
N Vent the system
See the sections in this instruction
manual on Connecting the Water Supply
and Venting the System.
See the Kohler owner's manual for
complete starting instructions.
Actuating the spray gun
N Direct the spray attachment towards
the surface to be cleaned
N Release the trigger lockout (1)
N Squeeze the spray gun trigger (2)
Standby mode
NOTICE
Running the engine for more than
2 minutes without active spraying can
cause serious damage to the pressure
washer.
Shut off the engine:
– before taking a break
– if leaving the machine unattended
– any time active spraying will be
interrupted for more than 2 minutes
Starting the Engine Working
0000-GXX-0330-A0
1
2
To Next Page
Loading...
