EN
23
0478 131 8349 A - EN
● Set the lowest cutting height (level 1).
(Ö 9.6)
● Place the robotic mower on its back on
a suitable surface.
Insert the battery (C) as shown and allow it
to engage.
Fit the cover (F) and tighten the
screws (G). Observe a maximum
tightening torque of 1 - 2 Nm.
● Set the robotic mower on its wheels.
9.6 Adjusting the cutting height
Lowest cutting height:
Level 1 (20 mm)
Highest cutting height:
Level 8 (60 mm)
Press and turn the rotary knob (1). It
engages again when released. The
marking (2) indicates the set cutting
height.
9.7 Notes on initial installation
An installation assistant is
available for installation of the
robotic mower. This program
guides you through the entire
initial installation process:
● Setting the language, date and time
● Installing the docking station
● Routing the perimeter wire
● Connecting the perimeter wire
● Linking the robotic mower and docking
station
● Checking installation
Set the cutting height to at least
level 5 in the first weeks (until the
grass has grown over the perimeter
wire) to prevent the perimeter wire
being damaged and to guarantee
reliable operation.
Levels 1, 2, 3 and 4 are special
heights for very level lawns (ground
unevenness < +/- 1 cm).
The rotary knob can be removed
upwards from the adjustment
element. This design is
implemented for safety reasons: it
ensures that the machine cannot be
lifted and carried by the rotary knob.
To Next Page
Loading...
Need help?
General
