0478 131 8349 A - EN
44
11.10 Settings
1. iMow:
Adapt machine settings
(Ö 11.11)
2. Installation:
Adapt and test the installation
(Ö 11.14)
3. Safety:
Adapt the safety settings (Ö 11.16)
4. Service:
Maintenance and service (Ö 11.17)
5. Dealer area:
This menu is protected by the
dealer code. Your specialist
dealer performs a variety of maintenance
and service operations with the aid of this
menu.
11.11 iMow – machine settings
1. Rain sensor:
The rain sensor can be set so that
mowing is interrupted or does not
start when it is raining.
● Set the rain sensor (Ö 11.12)
2. Mowing time:
Set the standard for the duration of a
mowing operation after activation of
the command "Start mowing". (Ö 11.5)
3. Delay:
Set the standard for the delay
following activation of the command
"Start time-delayed mowing". (Ö 11.5)
4. Status screen:
Select the information that is to
appear in the status screen.
(Ö 11.2)
● Set the status screen (Ö 11.13)
5. Time:
Set the current time.
The set time must correspond to the
actual time in order to prevent inadvertent
mowing by the robotic mower.
6. Date:
Set the current date.
The set date must correspond to the
actual calendar date in order to prevent
inadvertent operation of the robotic
mower.
7. Date format:
Set the required date format.
8. Track offset:
The robotic mower travels along the
perimeter wire at a 6 cm offset from
the wire as standard. With this offset,
optimum docking is ensured. The
iMow Ruler is also designed for a track
offset of 6 cm.
● Only if necessary, open the selection
window with OK and set the required
value (3 cm to 9 cm).
9. Language:
Set the required display language.
The language selected during initial
installation is set as the default.
10. Contrast:
The display contrast can be
adjusted as required.
11. Energy mode
(RMI 632 C, RMI 632 PC):
In Standard, the robotic mower is
connected to the Internet at all times and
can be reached using the app. (Ö 10.)
In ECO, radio communication is
deactivated during rest periods to reduce
energy consumption; the robotic mower
cannot be reached using the app. The
most recent available data is shown in the
app.
11.12 Setting the rain sensor
In order to set the 5-stage
sensor, press the control pad to
the left or right. The current
value is displayed in the "Settings" menu
by means of a line diagram.
Moving the control influences
– the sensitivity of the rain sensor,
– the time the robotic mower waits for the
sensor surface to dry following rain.
RMI 632 C, RMI 632 PC:
The time can also be set using the
app. (Ö 10.)
RMI 632 C, RMI 632 PC:
The date can also be set using the
app. (Ö 10.)
STIHL recommends that the
standard setting of 6 cm is not
changed.
To Next Page
Loading...
Need help?
General
