EN
29
0478 131 8349 A - EN
Completing wire routing:
● Check the fastening of the perimeter
wire to the ground. One fixing pin per
metre is sufficient as a rough guide. The
perimeter wire must always lie on the
lawn. Drive the fixing pins fully into the
ground.
● After completing this installation
work, press the OK button on the
control panel.
9.11 Connecting the perimeter wire
Place the robotic mower (1) within
the mowing area, behind the
docking station (2) as illustrated,
then press the OK button.
Disconnect the power supply unit
plug from the mains, then press the
OK button.
Remove the cover. (Ö 9.2)
Then press the OK button on the
control panel.
If the battery is not sufficiently
charged to work through the
remaining steps of the installation
assistant, an appropriate message
is displayed. In this case, leave the
robotic mower in the master
docking station and continue
charging the battery.
Jumping to the next step of the
installation assistant with the OK
button is only possible once the
necessary battery voltage is
available.
To Next Page
Loading...
Need help?
General
