STIHLER ELECTRONIC ASTOTHERM plus - Cable Break Alarm

10 Alarms and troubleshooting
ASTOTHERM PLUS Instructions for Use
33
10.3 Cable break alarm
Control panel
Device response
 The display shows „- - -„.
 The selection frame flashes.
 The green “On” LED lights.
 The “Start” LED flashes green.
 The “Alarm” LED lights yellow.
 The acoustic alarm signal sounds every 17 seconds.
 The heating element is switched off.
Alarm condition
A defect of the cable break detection or a temperature
sensor break has been detected.
Possible reason(s)
►Required
action(s)
Warmer is defective.
►Return ASTOTHERM PLUS to local sales office.
Possible actions to
clear
Press the “Standby” button to switch the device to
Standby Mode.
8
10
3
5
11
2
●