companies have not been tested or approved
by STILL.
CAUTION
The installation or use of such products may have a
negative impact on the design of the truck and thus
impair active or passive driving safety.
We recommend that you obtain approval from the
manufacturer and, if applicable, from the relevant
regulatory authorities before installing such parts.
The manufacturer accepts no liability for any damage
caused by the use of non-original parts and non-orig-
inal accessories.
Damage, faults
Any damage or faults observed on the truck or
the accessories must be reported immediately
to the responsible personnel. The truck and
accessories must never be used before they
are correctly reconditioned as they cannot be
guaranteed to be safe for operating or driving.
The safety mechanisms and switches must
never be removed or disabled. The predefined
setpoint values must not be modified.
Work on the electric installation (e.g. connect-
ing a radio, additional lights or other accesso-
ries) is permitted only with the approval of the
manufacturer.
Wheels and tyres
DANGER
Risk to stability!
Failure to observe the following information and in-
structions can lead to a loss of stability. The truck
may tip over — risk of accident!
The following factors can lead to a loss of sta-
bility and are therefore
prohibited
:
●
Wheels not approved by the manufacturer
●
Excessive wear to the tyres
●
Tyres of inferior quality
●
Changes to the wheel rims
●
Combination of wheels from different manu-
facturers
The following rules must be observed to en-
sure stability:
●
Only use wheels with equal and permitted
levels of wear to the tyres.
●
Only use tyres of the original tyre type.
●
Only use wheels approved by the manufac-
turer.
●
Only use high-quality products.
Safety
2
Basic principles for safe operation
275001 801 1555 EN - 12/2020
To Next Page
Loading...
