Troubleshooting
This chapter is intended to help users identify
and eliminate simple faults or problems
caused by operational errors.
Carry out the checks in the table below in se-
quence to determine the specific cause of the
failure.
Malfunction Possible reason Solution
Unable to drive the
truck
- The switch is locked in the OFF
position
- Battery power is too low
- A fuse is blown
- The truck is in charging mode
- Turn the key switch to the ON po-
sition
- Check the battery charge and
charge the battery if needed
- Check the fuse device
- Interrupt the charging process
Unable to lift goods
- The hydraulic oil level is too low
- Load capacity exceeded
- Check the hydraulic oil level
- Pay attention to the rated load (re-
fer to the model identification plate)
If you are still unable to resolve the fault after
performing all the steps listed in "Solutions",
please contact the company's customer serv-
ice department. Further fault identification and
elimination operations must be performed by
after-sales service personnel who have under-
gone special training.
Troubleshooting
7
Troubleshooting
78 5001 801 1555 EN - 12/2020
To Next Page
Loading...
