Cleaning
CAUTION
High-pressure cleaners, excessive water pressure or
water and steam that are too hot can damage com-
ponents. If water penetrates the electrical system,
there is a risk of a short circuit occurring!
– Do not use high-pressure cleaners for cleaning.
– Strictly adhere to the following steps.
Cleaning operations
Do not use combustible liquids to clean the
truck.
You must take all safety precautions before
you start cleaning and you must prevent
sparks from being produced during work pro-
cesses (such as from short circuit). If the truck
is powered by a rechargable battery, you must
disconnect it from the battery cable connec-
tions.
When cleaning electronics and electrical com-
ponents, you must use low-strength suction
gas or compressed air. You should also use a
non-conductive, anti-static brush to clean dust
off component surfaces.
If using a water hose or high-pressure equip-
ment to clean the truck, you must first carefully
seal all electronics and electrical components,
otherwise these components may get wet and
malfunction.
Do not use steam cleaning equipment.
After cleaning operations are completed, the
operating procedures specified in the "Putting
the equipment back into operation" section
must be carried out.
Operational safety and environmental protection
– The checks and maintenance operations
outlined in this section must be carried out
at the intervals set out in the maintenance
checklist.
– Modifying this truck, especially its safety de-
vices, is prohibited. It is strictly forbidden to
change the working speed of the truck.
– Only original equipment and spare parts
meet with company quality assurance re-
quirements. To ensure the equipment’s sta-
bility and operational performance, you
must only use original equipment manufac-
tured by our company. You must handle old
components and replacement of fluids in
accordance with current environmental pro-
tection regulations. Please contact our com-
pany’s customer service department if you
need to change the oil.
– After the inspection and maintenance oper-
ations are completed, the operating proce-
dures specified in the "Putting the equip-
ment back into operation" section must be
carried out.
Repairs and maintenance safety regulations
Personnel qualifications
Only qualified and authorised personnel are
allowed to perform maintenance work. Regu-
lar safety checks and checks after unusual in-
cidents must be performed by a competent
person. The competent person must conduct
their evaluation and assessment from a safety
standpoint, unaffected by operational and eco-
nomic conditions. The competent person must
have sufficient knowledge and experience to
be able to assess the condition of a truck and
the effectiveness of the protective devices in
accordance with technical conventions and
the principles for testing trucks.
Maintenance
6
Cleaning
66 5001 801 1555 EN - 12/2020
To Next Page
Loading...
