NOTE
Please observe the instructions and regula-
tions provided by the battery manufacturer.
– Spray all exposed contacts with a suitable
contact spray.
Recommissioning after storage
– Clean the truck thoroughly.
– Lubricate according to the truck's mainte-
nance schematic view.
– Clean the battery, apply special grease to
the electrode bolts, and install and fix the
terminals on the battery.
– Charge the battery.
– Check whether the hydraulic oil contains
condensation water. Change the hydraulic
oil if necessary.
– Put the truck into operation.
If there are difficulties with operating electrical
system switches, you should apply contact
spray to the exposed contact surfaces and re-
move the oxide layers on the surfaces of the
operating component contacts by performing
repeated switch operations. After putting the
truck into service, the driver should immedi-
ately carry out repeated brake performance
tests.
Maintenance
6
Decommissioning and storing the truck
74 5001 801 1555 EN - 12/2020
To Next Page
Loading...
