To Next PageTo Next Page
Need help?Do you have a question about the Stingl SR–500 and is the answer not in the manual?
Guidelines for addressing entrapment hazards in pools, hot tubs, and spas.
Requirement to remove all check valves from the system before installation.
The unit cannot be used as a disconnect means; a separate one is required.
Instructions on protecting the vacuum hose from freezing.
Technical specifications for the SR-500 unit and remote alarm.
Recommendation to use specific drain covers for hair entrapment prevention.
Instructions for mounting the SR-500 unit and its enclosure.
Various line voltage configurations for pump connections.
Wiring for low voltage applications, including heater delay and remote interfaces.
Description of the SR-500 front panel display and its features.
Explanation of the function of each pushbutton switch on the SR-500.
Detailed wiring steps for single-phase pumps within a specific HP/Amp range.
Explanation of the different run modes available for the SR-500.
Details on diagnosing and resolving System Error 11.
Information regarding System Error 17 and its causes.
Wiring instructions specific to the SR500 Rev. 2.00 combination unit.
Wiring steps for single-phase pumps for this unit version.
Procedure for setting the pump's start time.
Procedure for setting the pump's stop time.
Procedure for setting the unit's internal clock.
Procedures for setting the unit's year, month, and day.
How to select and use the Off/Stop modes.
How to select and use the On/Run modes.
Procedure to verify the SR-500's proper operation after setup.
Troubleshooting steps for when the unit shows no power or display.
Troubleshooting steps for incorrect power settings or wiring.
Troubleshooting for high vacuum errors.
Troubleshooting for low vacuum errors.
Explanation and troubleshooting for Error 11 related to pump relays.
Explanation and troubleshooting for System Error 17.
General