Set-Up Mode for Revision 1.10 and Revision 2.00 P/S Combo
Enter the SET-UP MODE by pressing the SET button when the unit is in the OFF
MODE. As soon as the SET button is pressed,
you will see this message in the display. Release
the SET button to continue.
For any of the SET-UP MODE functions, pressing the SET button serves two
purposes – it saves whatever function value was changed, and it also causes the unit
to skip to the next function in the SET-UP MODE.
The SET-UP MODE can be exited at any time by pressing the OFF/STOP button.
Exiting by pressing OFF/STOP will not save any changes to the currently displayed
function.
NOTE: if the unit is placed into the SET-UP MODE, it will automatically
return to the OFF MODE after 60 seconds of button inactivity. Any changes to
the currently displayed function will not be saved.
PUMP START TIME: The first selection in the
SET-UP MODE is pump start time. The unit
defaults to an 8:00AM start time. To change the
start time, press the (-) and (+) buttons. Holding the buttons will make the time
change faster. Changing the pump start time causes the pump stop time to be preset
to 12 hours later than the selected pump start time. Once the desired pump start time
is selected, press the SET button to save it, and skip to the next function.
PUMP STOP TIME: The next selection in the
SET-UP MODE is pump stop time. The unit
defaults to an 8:00PM stop time. To change the
stop time, press the (-) and (+) buttons. The time
will change in 15-minute increments. Holding the buttons will make the time
change faster. Once the desired pump stop time is selected, press the SET button to
save it, and skip to the next function.
NOTE: The pump stop time cannot be set closer than FIFTEEN (15) minutes
to the pump start time. If the stop time value shown stops changing when you
are pressing the (-/+) buttons, you are getting close to the start time.
TIME-OF-DAY CLOCK: The next selection in
the SET-UP MODE is the time-of-day clock time.
The unit defaults to 12:00PM (noon). To change
the time-of-day clock time, press the (-) and (+)
buttons. Holding the buttons will make the time change faster. Once the desired
time-of-day clock time is selected, press the SET button to save it, and skip to the
next function.
** SET-UP MODE **
RELEASE FOR NEXT
SET START (-/+)
TIME 08:00 AM
SET STOP (-/+)
TIME 08:00 PM
SET CLOCK (-/+)
TIME 12:00 PM
35
To Next Page
Loading...