Stoneridge Optimo - Connecting to Tachographs; Calibrating and Programming

10
6.2. Connecting to Tachographs
 3 dongles are supplied for Digital, 2400 and 1324 tachographs. These are inserted into the
programming socket as shown, wait 5 seconds after insertion before initiating programmes.
 All tachographs can also be connected using existing MKII cables via supplied adaptor cables.
This is the only way to connect to round tachographs.
 Optimo Light and Optimo
2
are supplied with the Digital dongle only.
6.3. Calibrating and Programming
 On tapping Optimo identifies the connected tachograph. If the tachograph
cannot be determined the screen below is displayed. Select
tachograph type.