26
For 3
rd
generation digital tachographs activated after 1
st
October 2012, the following screen is
displayed. 2
nd
source of motion is enabled by selecting the appropriate CANbus or the C3 option.
For CANbus “Heavy” or “Light” vehicle also has to be selected as data is transferred at different
bit rates.
If C3 is enabled, a speed factor, derived from the l factor value has to be entered to match the
two speed signals as close as possible, see table 1.
To force pair a digital sender, tap “Pair”.
Table 1
To Next Page
Loading...
