Stonex SC600 GNSS Receiver – User Manual
38
FOR USA
For your own safety, and in terms of the RF Exposure requirements of the FCC always observe the precautions
listed here.
• Maintain a minimum separation distance of 20 cm (7.8 inches) between yourself and the
radiating antenna.
• Do not collocate (place within 20 cm) the radio antenna with any other transmitting device.
Bluetooth/WIFI radio Module
The radiated output power of the internal Bluetooth module of this equipment is far below the FCC and EU
radio frequency exposure limits. In any case, be sure to use the equipment with the radio far at least 20 cm
from the human body. The Bluetooth module match the guidelines found in radio frequency “safety
standards and recommendations “published by Scientific organizations.
Stonex srl therefore believes the internal wireless radio is safe for use by end users. The level of energy
emitted is far less than the electromagnetic energy emitted by wireless devices such as UMTS phones.
However, the use of Bluetooth/WIFI may be restricted in some special situations or place, like aircraft,
hospital,etc. If you are unsure of existence of restrictions, you should ask for authorization before switching
on the Bluetooth radio.
Recommendation for installing antennas for internal radios
An absence of specific alerts does not mean that there are no safety risks involved in the use of this
equipment.
Always follow the instructions that accompany a Warning or Caution, reported in this. This information is
intended to minimize the risk of personal injury and/or damage to propriety. In particular, observe safety
instructions that are presented in the following form:
CAUTION
For your own safety, and to match the RF Exposure requirements of the FCC, always
observe these precautions:
Always maintain a minimum separation distance of 20 cm (7.8 inches) between yourself
and the radiating antenna.
Do not collocate (place within 20cm) the radio antenna with any other transmitting
device.
Do not switch on the GSM or UHF module without the antenna mounted to the
external connector.
UHF Antennas having a gain greater than 5 dBi, are strictly prohibited for use with this device. The required
antenna impedance must be 50 ohms.
To Next Page
Loading...
Need help?
General
