WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
47
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
WALLS INSULATION
PRO TIP
Mark the wall stud locations on the floor and ceiling at least 6" out to make location of the studs
easier when installing the insulation.
• Measure and cut two 2" sheets of R-max to fit over the studs of the back wall covering the air
conditioner opening.
NOTE THAT THE INSULATION GOES OVER THE STUDS AND NOT IN BETWEEN THE STUDS. THIS
IS IMPORTANT TO ENSURE MAXIMUM R-VALUE.
• Flush the edge of the insulation with the exterior of the left and right cooler walls.
• Put the sheets of R-max in place and fasten to the studs with #12 x 3" long plastic cap nails.
To Next Page
Loading...
