WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
70
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
SHED EXTERIOR FINISHES
Now it is time to put the last touches on our Shed-Style cooler.
EXTERIOR DOOR TRIM
• Measure and cut two 1x4 exterior trim boards to frame your door on the sides. Cut them ~5 ½”
longer as you will have to cut the top of your board at 45° to meet the horizontal trim piece.
• Measure and cut one 1x4 trim piece for the top of the door with both ends at 45°.
• Using finishing nails attach the trim to the door frame.
SOFFIT
• We used a 96” 1x6 board for the soffit. If a 1x6 is too wide you can cut a 96” long piece of OSB
or plywood to fit in between the fascia board and the wall.
• Nail the soffit board into the rafters using galvanized nails.
To Next Page
Loading...
