WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
57
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
• Finish by cutting and gluing FRP to cover any exposed insulation around the doorway.
ELECTRICAL
Once your cooler is built and insulated, have a certified electrician install the electrical for the air
conditioner, CoolBot, lights, and any other accessories you may add to your cooler.
On occasion, condensation may drip from the front of your air conditioner so make sure all electrical is
mounted to the side of the air conditioner and not directly beneath.
We recommend surface mounting all electrical boxes inside of the cooler to minimize compromising the
insulation integrity and to reduce the chance for condensation within the electrical box.
After your electrical boxes are installed use electrical insulation putty to seal the entrance of the conduit
into the electrical boxes to reduce the chances of warm air getting inside and creating condensation due
to the lower temperature of the cooler.
To Next Page
Loading...
