WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
50
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
• Taping the corners is a bit trickier yet with proper technique is easily achieved.
• Cut the tape to match the length of the joint and remove the first 12" of backing paper.
• Cup the tape inward toward the wall and apply the tape to only one wall.
• Remove another 24" of backing paper and pull tight and again apply to only one wall.
• Repeat until the entire strip is attached to one wall.
• Go back to the top and with your fingers on the side of the tape that is taped to the wall slide
your finger towards but not all of the way to the corner.
To Next Page
Loading...
