WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
9
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
Treated Ground Contact lumber is used for the Floor-Base of the cooler as it will be directly on the floor.
White wood is not treated and used for all other boards in construction of the cooler.
• For the FLOOR BANDS we are using two 8 ft 2 x 6s.
• For the FLOOR JOISTS cut seven treated 2x6s to a length of 93 inches.
• Mark all seven 2 x 6s (FLOOR JOISTS) locations on the FLOOR BANDS with a pencil and straight
edge to identify the edge of the mating 2 x 6s (FLOOR JOISTS) - see diagram above on p8.
• Mark an "X" on the side of the line that will be covered by the mating 2 x 6.
• On a flat surface with a backstop that will not move layout all seven 2 x 6s (FLOOR JOISTS).
All nails used with treated lumber must be galvanized to prevent corrosion of the nails. Galvanized
nails have a rough dull silvery appearance.
To Next Page
Loading...
