STOVES 61GDO - Setting the Time of Day; Setting the Minute Minder; Alarm Tone Selection

Programmer / Clock
To set the time of day
u
Press the Plus and Minus buttons
together for a few seconds, and
release.
u
The ‘
l
’ in between the numbers on
the LED Display will begin to flash.
u
While the ‘
l
’ is flashing it is possi-
ble to adjust the time using the Plus
and Minus buttons. Once the time has
been set, allow approximately 30 sec-
onds before using any of the other
timer functions. This ensures that the
time will remain correct.
To select an alarm tone
There are three tones to chose from.
u
Press the minus button to listen to the
first tone.
u
Release the minus button and press it
again to listen to the second tone etc.
u
Releasing the minus button after the
tone has sounded will automatically
select that tone
Setting the minute minder
u
To set the Minute Minder, press the
Function button once. The bell symbol
will appear and start flashing. The
flashing only lasts for 5 seconds so the
time must be set within this time frame.
u
Use the Plus and Minus button to set
the length of time required. Once this
has been done, the Minute Minder is
set.
u
When the desired length of time has
counted down the alarm will sound.
u
To cancel the tone, press any of the
buttons.
u
To cancel the Minute Minder at any
time, press the Plus and Minus buttons
together.
A
18
08 27127 00-61GDO 5/8/04 11:31 AM Page 20