5.2 Install Packs- Wall Mounted CDBO 1.2Kw Pack
20
The wall mounted COBO 1.2Kw Pack (Terminal Strip 1.2Kw Pack) provides load
and control terminal strips on the rear panel of the pack, and provides a termina-
tion for remote overtemp indication.
A. Set mounting hardware in wall according to the figure.
B. Remove top of pack and mount on wall. Make certain that the fan is at
the bottom of the unit as mounted.
C. Attach conduit as indicated for power, load, and control wires, and pull
wiring. Bring wires into pack as shown. This configuration is designed
for minimum crosstalk between the AC line and the control wiring.
Keep Clear
-Ami:~~•~, .. I
20.5' (52.1 cm)~
1-16' (40.6cm)---t--j I
Knockout For
Control Wires
LEFT
SIDE
nockout For \ /
T* ~-1
;- Control
-++,[}
Power Wirr Mounting Holes
23.5' 20.25'
(59.7cm) +
~~II~~
Jj-lom)
TOP (COVER REMOVED)
l-=10--:--I-Air Intake Area
I (25.4cm) I Keep Clear
T c::J
RIGHT
SIDE
8.5'
(29.85cm)
Knockout For
Power Wires
l_ '--,I'--='-----=--'
Air Inlet Fan
Figure 3. CD80 1.2Kw Pack Wall Mounting
Panel
Primary
Circuit
Breakers
To Next Page
Loading...
