Strand Lighting CD80 - Basic Component Layout; Chassis; Control Electronics (Multiplexed Analog Input); Control Module (Discreet Analog Input)

4. Basic Co,nponint Layout .............................................................................. 11
4.1 Chassis ......................................................................................................................... 11
4.2 Control Electronics (Multiplexed Analog Input) ....................................................... 12
4.3 Control Module (Discreet Analog Input) .................................................................. 13
4.4 Power Control and Cooling Assemblies .................................................................. 13
Operation
This section provides information on installation and operation of COBO 1.2Kw Packs.
5. Installation ...................................................................................................... 19
5.1 Install Packs - Portable COBO 1.2Kw Pack .................................................................. 19
5.2 Install Packs
- Wall Mounted COBO 1.2Kw Pack ....................................................... 20
5.3 Connect Control Signal ............................................................................................. 21
5.4 Set Thumbwheel Switches ........................................................................................ 22
5.5 Systems with Multiple Control Cables ........................................................................ 22
5.6 Mixing COBO Packs ................................................................................................... 23
5.7 Analog Control Module Hookup ............................................................................. 23
5.8 Set Phase Changer ................................................................................................... 24
5.9 Connect Power ........................................................................................................ 24
5.1
o Fault Protection ........................................................................................................ 24
5.11 Test Controller .............................................................................................................. 24
6. Di,nmer Pack Calibration .............................................................................. 31
6.1 Ramp Card Calibration .............................................................................................. 31
6.2 Power Supply Card Calibration ................................................................................... 31
ii